IBM HS40 User Guide - Page 41
Installing, memory, modules
![]() |
UPC - 000435160188
View all IBM HS40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
6. Place the IDE drive tray from the option kit over the riser card as shown in the illustration, aligning the tray with the screw holes on the I/O board. Two of the screw holes have screws in them. 7. Remove the tray temporarily; then, remove the two screws from the screw holes on the I/O board and replace the tray. Secure the tray to the I/O board with screws from the kit. 8. Set any jumpers or switches on the IDE drive. Important: Both IDE drives must be set to Master. Attention: Do not press on the top of the IDE drive. Pressing the top could damage the IDE drive. 9. Place the IDE drive into the tray and push it, from the rear edge of the IDE drive, into the connector on the riser card until the IDE drive moves past the lever at the back of the tray. The IDE drive clicks into place. 10. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 44. Installing memory modules The following notes describe the types of dual inline memory modules (DIMMs) that the blade server supports and other information that you must consider when installing DIMMs: v The processor board contains eight DIMM connectors and supports two-way memory interleaving. v The DIMM options supported for your blade server are 256 MB, 512 MB, 1 GB, and 2 GB. Your blade server supports a minimum of 512 MB and a maximum of 16 GB. v You might have to enable large-memory support for your operating system to access all of the memory that is installed in your blade server. See the documentation for your operating system for information. v Your blade server comes with two or more DIMMs installed, in pairs, starting with the DIMM 4 (J9E1) and DIMM 8 (J9H1) memory connectors. When you install additional DIMMs, be sure to install them as pairs, in the connectors and order shown in the following table. Pair DIMM connectors First Second Third Fourth 4 (J9E1) and 8 (J9H1) 3 (J9D1) and 7 (J9G1) 2 (J9C2) and 6 (J9F1) 1 (J9B3) and 5 (J9E2) v Both DIMMs in a pair must be the same size, speed, type, and technology. You can mix compatible DIMMs from various manufacturers. v If you are using the hot-spare memory feature, all DIMMs that are installed in the blade server must be the same size, speed, type, and technology. If you are not using the hot-spare memory feature, the DIMMs of one memory pair do not have to match the DIMMs of the other memory pairs. To use the hot-spare memory feature, at least two DIMM pairs must be installed in the blade server. The hot spare memory feature is enabled using the Configuration/Setup Utility program (see "Configuration/Setup Utility menu choices" on page 52 for information). Chapter 3. Installing options 27
![](/manual_guide/products/ibm-hs40-user-guide-5a9fb4f/41.png)