IBM HS40 User Guide - Page 58
Completing, installation
UPC - 000435160188
View all IBM HS40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
a. Use your fingers to pinch the battery retainer; then, rotate the battery up and out from its socket. b. Use your fingernail to slide the battery out from under the battery clip. 7. Insert the new battery: a. Tilt the battery so that you can insert it into the socket, under the battery clip. b. As you slide it under the battery clip, press the battery down into the socket until the battery retainer secures it in place. 8. Close the blade server cover (see "Closing the blade server cover" on page 46). Statement 21: CAUTION: Hazardous energy is present when the blade server is connected to the power source. Always replace the blade cover before installing the blade server. 9. Reinsert the blade server into the bay in the BladeCenter unit. 10. Turn on the blade server. 11. Start the blade server Configuration/Setup Utility program and set configuration parameters as needed (see "Using the Configuration/Setup Utility program" on page 51 for information). Completing the installation To complete the installation, perform the following tasks. Instructions for each task are in the following sections. 1. Reinstall the blade server bezel assembly, if you removed it (see "Installing the blade server bezel assembly" on page 45). Attention: To help ensure proper cooling and system reliability the air baffle must be correctly positioned and fully seated. 2. Close the blade server cover, unless you installed the SCSI storage expansion unit option (see "Closing the blade server cover" on page 46). 44 BladeCenter HS40 Type 8839: Installation and User's Guide