IBM HS40 User Guide - Page 74
Important, Devices, Ports, Configuration, Enabled, Disabled, Settings, Initialize, Array
![]() |
UPC - 000435160188
View all IBM HS40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
4. Make sure that two IDE hard disk drives are installed in the blade server (see the "Installing an IDE drive" on page 25 for instructions). Important: To avoid potential performance and reliability problems when configuring or replacing hard disk drives in a mirrored RAID configuration, make sure that the storage capacities and speeds of the hard disk drives are identical. 5. Create a diskette or CD containing the IDE RAID device drivers for your operating system. The latest IDE RAID device drivers for supported operating systems are available for download from the IBM Support Web site at http://www.ibm.com/pc/support/. 6. Complete the following steps to enable IDE RAID in BIOS using the Configuration/Setup Utility program: a. Turn on the blade server and watch the monitor screen. b. When the message Press F1 for Configuration/Setup appears, press F1. c. Select Devices and I/O Ports from the Configuration/Setup Utility main menu; then, select IDE Configuration. d. Set the IDE RAID feature to Enabled (the default setting is Disabled). e. Select Save Settings from the Configuration/Setup Utility main menu. f. Exit the Configuration/Setup Utility program, making sure that you save the settings. The blade server restarts automatically. 7. Complete the following steps to configure IDE RAID in BIOS using the MegaRAID IDE Setup Utility program: a. When the message Press Ctrl+M to run MegaRAID IDE Setup Utility appears, press Ctrl+M. b. From the MegaRAID IDE Setup Utility program, select the automatic configuration option (F1 or F2) for the type of RAID array you are setting up. You can also manually configure the RAID array (F4) using the MegaRAID IDE Setup Utility program; however, your blade server supports only RAID level-0 (stripe) or RAID level-1 (mirror). Attempting to manually configure any other type of RAID array will cause an error. c. Select Initialize Array; then, press Enter. Using the Spacebar, select the logical drives that will be part of the RAID array. d. Press F10 to save the changes and exit the MegaRAID IDE Setup Utility program. The blade server restarts automatically. Status messages that are displayed during restart indicate status of the RAID array. 8. Install the operating system on your blade server, making sure that you install the correct IDE RAID device drivers (see Chapter 5, "Installing the operating system," on page 63 for instructions). The latest IDE RAID device drivers and NOS installation instructions for supported operating systems are available for download from the IBM Support Web site at http://www.ibm.com/pc/support/. Note: Some operating systems allow device drivers to be installed only during a short period of time during operating-system setup; make sure you pay attention to all messages that are displayed. Use care when performing an unattended operating-system installation for IDE RAID. 9. Perform additional IDE RAID configuration that is required for your operating system or application, using the operating-system configuration tools and the MegaRAID IDEal Software RAID utility. See your operating-system documentation for information about using the operating-system tools for IDE hard disk drive RAID configuration. The latest version of the MegaRAID IDEal 60 BladeCenter HS40 Type 8839: Installation and User's Guide
![](/manual_guide/products/ibm-hs40-user-guide-5a9fb4f/74.png)