Intel S1200RP Service Guide - Page 50
Installing and Removing Hot-swap Hard Drive, Installing a Hard Disk Drive into 3.5\
View all Intel S1200RP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Hardware Installations and Upgrades Installing and Removing Hot-swap Hard Drive Caution: If you do not install all drives, empty drive bays must be occupied by carriers with plastic drive blank provided to maintain proper system cooling. Installing a Hard Disk Drive into 3.5" Hard Drive Carrier 1. Remove the drive carrier by pressing the green button and opening the lever (see letter A). Slide the carrier out (see letter B). Figure 39. Installing Hard Disk Drive - Removing 3.5" HDD Carrier 2. Remove the four screws securing the HDD interface bracket and remove the HDD interface bracket (see letter C). Figure 40. Installing Hard Disk Drive - Removing 3.5" HDD Interface Bracket 3. Install the hard disk drive using the same four screws as shown. Make sure the connector end of the drive matches the backplane connector (see letter D). Figure 41. Installing Hard Disk Drive - Installing 3.5" HDD 38 Intel® Server System R1000RP Service Guide