Intermec PM43/PM43c PM23c, PM43, and PM43c Mid-Range Printer User Manual - Page 51
Print, Wizards > Calibration > Media, Services > Media, Calibration, black mark
View all Intermec PM43/PM43c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Chapter 2 - Set Up the Printer 5 Route the ribbon through the print mechanism and pull out approximately 20 cm (8 inches) of ribbon leader. The dotted line in this illustration shows how to load ribbon with the ink wound in. 6 Turn the ribbon takeup hub counterclockwise until the ribbon becomes tight and runs wrinkle-free through the print mechanism. 7 Load media. 8 Turn the printhead lift lever clockwise to lower the printhead. 9 Close the media cover. 10 Press the Print button to advance the media. 11 Configure the printer for the correct media type: media with gaps, black mark, continuous fixed length, or continuous variable length. 12 Set the print method to ribbon (TTR). 13 Calibrate the sensors on the printer. You can calibrate the media from the Main Menu (Wizards > Calibration > Media) on a full touch printer or from the web page (Services > Media Calibration) for all models of the printer. PM23c, PM43, and PM43c Mid-Range Printer User Manual 37