JVC DD-3 Instructions - Page 17
unit on Connecting the power cable
UPC - 046838029998
View all JVC DD-3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Preparation English NOTE • This system supports up to HDMI version 1.0. The HDMI video signal type can be checked with the "HDMI" indicator in the display window. (Refer to "Selecting the video signal type" shown on the right.) • If the picture is distorted while an HDMI TV is connected, turn off the main unit and turn it on again. • A TV compatible with HDCP (High-Bandwidth Digital Content Protection) can also be connected to the [HDMI] terminal, so that the uncompressed HD video signal type can be output as well. ■ CAUTION • Do not connect an S-video cable and a component video cable at the same time. Otherwise the picture may not be played back properly. • Connect the main unit directly to a TV (or a monitor) without routing through a video cassette recorder (VCR). Otherwise picture distortion may occur during playback. (Routing the connection through a VCR, however, does not affect the audio quality.) Main unit VCR TV (or monitor) Direct connection • Connecting the main unit to a VCR-built-in-TV may also cause picture distortion during playback. Selecting the video signal type To view an image on the TV screen, select the video signal type correctly according to the TV after connecting the main unit to the TV. 1 Turn on the main unit. (Refer to "Connecting the power cable" on page 15 and "Turning on the main unit" on page 16.) 2 Hold down [SCAN MODE] for 2 or more seconds. • The current video signal type flashes. Example: (Continued on the next page) 12