JVC GY-DV700WUCL Instruction Manual - Page 54

8. PLAYBACK MODE 8-1 Playback Procedure 2. TV . ZOOM C 16 11 8 5.6 20 m 8.7 30 ∞ ft 10 5 7 10 15 ASPHERIC & IF 19x 3 2 5 1.5 FUJINON M O FILTER 1 3200k 2 5600k+1/8ND 3 5600k 4 5600k+1/64ND SHUTTER STATUS A CR MENU ALARM MONITOR AUTO IRIS FULL AUTO BLACK BACK L NORMAL SPOT L STRETCH NORMAL COMPRESS LOLUX PRST A B ON KNEE OFF AUTO BARS CAM HML SAVE STBY VTR GAIN OUTPUT WHT.BAL NG POWER ON OFF OPERATE/WARNING RESET MONITOR SELECT CH-1 AUDIO CH-2 LEVEL LIGHT ON OFF COUNTER CTL TC UB 1. POWER switch 2. EJECT switch EJECT LOG REW STOP FF PLAY STILL 6. STOP button 4. STILL button 3. PLAY button 5. Operation 1. Set the POWER switch to ON. 2. Load the recorded videocassette correctly. • Slide the EJECT switch to the side. When the cassette cover opens, insert the videocassette and then close the cassette cover again. Ⅲ When a recordable videocassette (with the switch on the back of the cassette set to REC) is loaded, the unit enters the record-pause mode (STBY mode). In this case, press the STOP button to release the recordpause mode. 3. Press the PLAY button. a The LED indicator above the PLAY button lights and playback starts. • During playback of a recording made in the WIDE (16:9 picture) mode, the "WIDE" indicator is displayed in the counter display. The "WIDE" indicator is not shown if the recording was made in the NORMAL (4:3 picture) mode. CH 1 CH 2 40 30 20 10 32k 48k AUD LOCK SP MENU WIDE SLAVE H OVER AUTO OFF DEW 0 dB OVER SERVO RF L i PB NDF HOLD M S F "WIDE" indicator 4. Press the STILL button to stop playback temporarily. a The LED indicator above the STILL button lights and the unit enters the still mode. 5. To re-start playback, press the PLAY button. a The LED indicator above the STILL button goes out and playback starts again. 6. To stop playback, press the STOP button. a The LED indicator above the PLAY button goes out and the unit enters the stop mode. 54 CAUTION: • When the still picture mode or stop mode has continued for about 30 minutes, the unit automatically switches to the save mode to protect the tape. The time until the tape protect mode is initiated can be set to 3 or 30 minutes with the VCR Setup Menu item No. 307 LONG PAUSE TIME. When used in a cold environment, the setting will be 3 minutes regardless of the setting on the VCR Setup Menu. • Noise may appear in the picture during still mode. • When the automatic tracking function is activated at the start of the playback mode, digital noise may appear on the playback image. • This unit does not allow manual tracking adjustment. • When playing back a tape recorded on another unit, digital noise may appear during playback. • When turning on the power with the tape inserted or after loading a tape, the built-in head cleaner will emit a sound while operating. This does not indicate a malfunction. Memo: • If a tape recorded in the WIDE mode is played back on a 4:3 aspect ratio monitor TV, it is displayed as a squeezed image (stretched vertically). Playback of tape recorded in WIDE mode 4:3 aspect ratio monitor 16:9 aspect ratio monitor • When playing back a tape that is recorded in the WIDE mode, an ID signal for identifying the WIDE screen mode is output via the Y/C OUT connector superimposed on video signal.