JVC HR-S9911U Instructions - Page 8
Tuner Setting, Cable Box and/or DBS Receiver Control, Setting, Setting channels automatically
UPC - 046838160684
View all JVC HR-S9911U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Tuner Setting ● Turn on the VCR and TV, and select the VCR channel (or AV mode). ● Set the VCR/TV/CABLE/DBS selector on the Remote to "VCR". Setting channels automatically - Auto Channel Set Perform Auto Channel Set only if channels have not been set correctly by the Plug&Play setting. A Access Main Menu screen, then Tuner Set screen Press MENU on the Remote. Press rt to move the highlight bar (arrow) to "TUNER SET", then press OK or e. B Perform Auto Channel Set Press rt to move the highlight bar (arrow) to "AUTO CHANNEL SET", then press OK or e. The VCR selects the correct band (TV or CATV) automatically during Auto Channel Set. ● When Auto Channel Set is complete, "SCAN COMPLETED" appears on screen. ● If the scan was unsuccessful, "SCAN COMPLETED-NO SIGNAL-" appears on screen. Check the connections and start again. Press MENU to return to normal screen. Cable Box and/or DBS Receiver Control Setting The following procedure is required if you receive your TV channels through a cable box (descrambler) and/or if you receive satellite channels through DBS (Direct Broadcast Satellite) receiver. The supplied Controller allows the VCR to automatically switch the cable box or DBS receiver's channel during timer recording. NOTES: ● For the cable box, the Controller is effective for VCR Plus+ system or Express timer programing. ● For the DBS receiver, the Controller is effective only for Express timer programing. ● When connecting your cable box or DBS receiver, refer to its instruction manual. ● Turn on the VCR and TV, and select the VCR channel (or AV mode). ● Set the VCR/TV/CABLE/DBS selector on the Remote to "VCR". A Situate Controller If both a cable box and a DBS receiver are used, position the Controller so its signal reaches the remote sensors on both the cable box and DBS receiver. B Attach Controller Fix securely using the adhesive strip attached on the back of the Controller. Cable box or DBS receiver Setting channels manually - Manual Channel Set You can add the channels you want or delete the channels you do not want manually. A Access Main Menu screen, then Tuner Set screen Press MENU on the Remote. Press rt to move the highlight bar (arrow) to "TUNER SET", then press OK or e. B Access Manual Channel Set screen Press rt to move the highlight bar (arrow) to "MANUAL CHANNEL SET", then press OK or e. Your VCR Controller (suggested locations) C Connect cable box and/or DBS receiver to VCR Cable box or DBS receiver Transmitter RF output Audio/video output or Controller C Add or skip desired channels To add channels A Press the Number keys on the Remote to input a channel number you want to add. B Press OK or e to set to "ADD". C Repeat A to B to add other channels. Press MENU to return to normal screen. To skip channels A Press rt or the Number keys to select a channel number you want to skip. B Press OK or e to set to "SKIP". C Repeat A and B to skip other channels. Press MENU to return to normal screen. After a power failure occurs, band selection will be reset to "CATV". To ANTENNA IN To AUDIO/VIDEO IN VCR ● If your cable box or DBS receiver does not have audio/video output connectors, connect the RF output terminal on the unit to the ANTENNA IN terminal on the rear of your VCR. ● If your cable box or DBS receiver has audio/video output connectors, connect an audio/video cable between the AUDIO/ VIDEO IN connectors on the rear of the VCR and the audio/ video output connectors on the unit. ● If both a cable box and a DBS receiver are used, it is recommended that you connect the DBS receiver to your VCR's AUDIO/VIDEO IN connectors and the cable box to your VCR's ANTENNA IN connector. -8-