Kenwood DPX501 Instruction Manual - Page 13
Audio Setup
View all Kenwood DPX501 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3 Select the Detail Audio item to adjust Press the [VOL] knob. Each time you press the knob, the item to be adjusted alternates between the items shown in the table below. 4 Adjust the Detail Audio item Turn the [VOL] knob. Bass level Adjustment Item Bass Center Frequency Bass Q Factor Bass Extend Display Range "Bass FRQ" 40/50/60/70/80/100/ 120/150 Hz "Bass QFactor" 1.00/1.25/1.50/2.00 "Bass EXT" OFF/ON Middle level Adjustment Item Display Range Middle Center Frequency "Middle FRQ" 0.5/1.0/1.5/2.0 kHz Middle Q Factor "Middle 1.00/2.00 QFactor" Treble level Adjustment Item Display Range Treble Center Frequency "Treble FRQ" 10.0/12.5/15.0/17.5 kHz 5 Exit the Detail Audio Control mode Press the [VOL] knob for at least 1 second. • When you set the Bass Extend to ON, low frequency response is extended by 20%. • You can exit the Audio Control mode at anytime by pressing any button except for [VOL] and [ATT] buttons. Audio Setup Setting the Sound system, such as Cross over Network. 1 Select the source to adjust Press the [SRC] button. 2 Enter Audio Setup mode Press the [VOL] knob for at least 1 second. 3 Select the Audio Setup item to adjust Press the [VOL] knob. Each time you press the knob, the item to be adjusted alternates between the items shown in the table below. 4 Setup the Audio item Turn the [VOL] knob. Adjustment Item Display Front High Pass Filter*2 "HPF-F Fc"/ "HPF" Rear High Pass Filter*2 "HPF-R Fc"/ "HPR" Low Pass Filter*1,2 "LPF-SW"/ "LPF" Subwoofer Phase*1,2,3 "SW Phase"/ "PHAS" Volume offset "Vol-Offset"/ "V-OFF" Loudness "LOUD" Dual Zone System "2 ZONE"/ "2ZON" Range Through/40/60/80/100/120/ 150/180/220 Hz Through/40/60/80/100/120/ 150/180/220 Hz 50/60/80/100/120/ Through Hz Reverse (180°)/ Normal (0°) -8 - ±0 OFF/ON OFF/ON • Volume offset: Sets each source's volume as a difference from the basic volume. • Loudness: Compensates for low and high tones during low volume. • *1 You can control this item when (page 39) is set to "SWPRE SW". (DPX501 only) • *1 You can control this item when (page 14) is set to "SW ON". • *2 You can control this item when "2 ZONE"/ "2ZON" of (page 13) is set to "OFF". • *3 You can control this item when Low Pass Filter is not set to Through. • Dual Zone System Main source and sub source (Auxiliary input) output Front channel and Rear channel separately. - Set up the channel of sub source by (page 42). - Select Main source by [SRC] button. - Adjust the volume of Front channel by [VOL] knob. - Adjust the volume of Rear channel by (page 12). - The Audio Control has no effect on sub source. • You can use the Dual Zone System with the internal auxiliary input. 5 Exit Audio Setup mode Press the [VOL] knob for at least 1 second. English | 13