Kenwood DPX501 Instruction Manual - Page 42
G-Analyzer Stop Watch, Dual Zone System Setting, B.M.S. Bass Management System
View all Kenwood DPX501 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Menu system Function of the DPX701 G-Analyzer Stop Watch The control of stop watch can be started by GAnalyzer function. • Do not use G-Analyzer stop watch on the Public roads. 1 Select G-Analyzer Stop Watch mode Push the Control knob towards [FM] or [AM]. Select the "Stop Watch" display. 2 Enter G-Analyzer Stop Watch mode Press the Control knob for at least 1 second. "Stop" is displayed. 3 Enter Counter Ready mode Press the Control knob. "Ready" is displayed. 4 Start Count When G in the vertical direction is detected during the travel, the count automatically starts. "Running" is displayed. • You can also start the counter by pressing the Control knob. 5 Stop Count Press the Control knob. "Stop" is displayed. • The control will start again when you accelerate or press the Control knob. Do the operation after step3. When you Reset the Count (While "Stop" is displayed) Press the Control knob for at least 2 seconds. Other than Standby mode/ When the Dual Zone System is ON Dual Zone System Setting Setting the Front channel and Rear channel sound in the Dual Zone System. Display "Zone2 : Rear"/ "ZONE2 R" "Zone2 : Front"/ "ZONE2 F" Setting Sub source (Auxiliary input source) is to be rear channel. Sub source (Auxiliary input source) is to be front channel. Function of the DPX701 Other than Standby mode B.M.S. (Bass Management System) Adjust the bass boost level of the external amplifier using the main unit. Display "AMP Bass : Flat" "AMP Bass : +6" "AMP Bass : +12" "AMP Bass : +18" Setting Bass boost level is flat. Bass boost level is low (+6dB). Bass boost level is mid (+12dB). Bass boost level is high (+18dB). • Refer to the catalog or instruction manual for power amplifiers that can be controlled from this unit. • For amplifiers, there are the models you can set from Flat to +18 dB, and the models you can set from Flat to +12 dB. When an amplifier that can only be set to +12 is connected to the unit, "AMP Bass : +18" will not work correctly even if it is selected. • You can reset of count when the count is stopped. 6 Exit G-Analyzer Stop Watch mode Press the [MENU] button. • When "Running" is displayed (counted), the count is continued even though G-Analyzer Stop Watch mode is finished. If you want to stop the count, enter the menu mode then press the control knob. • When Power off (ex; ACC OFF) while counting, the value of 1 second or less will be "00". 42 | English