Kyocera KM-1815 1815 Operation Guide (Basic) Ver 1.1 - Page 74
Low Power Mode, Auto Sleep, Low power
View all Kyocera KM-1815 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Basic Operation Low Power Mode The machine has a Low Power Timer that is used to conserve power when the machine is not copying, scanning, printing, or receiving data. You can adjust the timer timeout time, the length of time (between 1 minute and 240 minutes) the machine waits before entering low power mode in the absence of data. The factory default time is 5 minutes. The machine wakes from low power mode whenever any one of the keys on the operator panel is pressed, an original is set from document processor, the cassettes or MP tray are opened or closed, or a print job is received. Low power * Notes • To set Low Power mode engages. For details, refer to Chapter 5 Advanced Operation Guide, Low Power Timer. • When Low Power mode is engaged, the optical lamp will be dimly lit. Auto Sleep The machine has an Auto Sleep Timer that is used to conserve power when the machine is not copying, scanning, printing, or receiving data. You can adjust the timer timeout time, the length of time (between 1 minute and 240 minutes) the machine waits before entering auto sleep mode in the absence of data. The factory default time is 30 minutes. The machine starts counting auto sleep time after the lower time expires. For example, when the low power timer timeout is 5 minutes and auto sleep timeout is 10 minutes, the machine enters auto sleep mode after 15 minutes. To engage the auto sleep manually, Press and hold the Reset/Power key for at least two seconds. The auto sleep mode will engage immediately. The machine wakes from auto sleep mode whenever press and hold the Reset/Power key for at least two seconds or a print job is received. Note When the Auto Sleep is engaged, all power to the machine, except that to the operation panel, is turned off. When the power switch is turned off ({), all power to the machine, including to the operation panel, is turned off. To enable copying or scanning again, press the Power/Reset key. Note To set the amount of time before the Auto Sleep engages. For details, refer to Chapter 5 Advanced Operation Guide, Auto Sleep Timer. 4-12