Lexmark C912 Service Manual - Page 197

5055-xxx 4. Lift the cover. Warning: Do not use pointed objects to remove the paper. They may damage the transfer belt. Note: The paper may be covered with unfused toner, which can stain garments. 5. Remove any paper on the transfer belt. If the paper source was the multipurpose feeder, check the area between the multipurpose feeder and the transfer belt. 6. Check the fuser area and top cover for additional jams. If there is no jammed paper in the fuser area or top cover, go to step 12. If jammed paper is present, continue with step 7. 7. Lift the fuser pressure release lever. 8. Slowly pull the paper out toward the inside of the printer. 9. Rotate the fuser pressure release lever down. Note: The top cover will not close until the lever is in the down position. 10. Check the top cover for additional jams. If none, go to step 12. 11. Remove the jam. 12. Place both hands on the top cover. 13. Press down firmly until the top cover clicks into place. 14. Rotate the top cover locking lever to the right. If you cannot rotate the locking lever, the cover is not fully closed. 15. Open the jam access door on the left side of the printer. 16. Remove any paper inside the printer. 17. Close the jam access door. To prevent additional paper jams, make sure both sides of the door are closed. 18.Close the front door. 19.Press Go. If the paper jam message continues, check and clear all paper from the paper path. Diagnostic aids 3-47