Lexmark C912 Service Manual - Page 244

5055-xxx 7. Place the finisher interface cable and power cord into the cable holder. 8. Close the cable holder. 9. Replug the power cord into the outlet and turn the printer on. The finisher does not have a power switch. Power is controlled by the printer. Hole punch adjustment You can adjust the hole punch alignment by approximately 4 mm (3/16 in.). This adjustment is useful when you want to center the punched holes onto the paper or if you hole punch a printed job on different finishers. Note: The following procedures are used for both three and four hole punch finishers. 1. Verify the alignment of the printer and finisher is correct. • If the alignment is not correct, go to "Aligning the finisher and printer" on page 3-80, and then print and hole punch another sheet of paper and see if an adjustment is needed. • If an adjustment is needed, continue with step 2. 2. Using a sheet of paper previously punched from the finisher, fold the paper so the bottom punched hole is aligned with the top punched hole. 3-94 Service Manual