Lexmark C912 Service Manual - Page 211

5055-xxx Finisher The finisher communicates with the host engine through serial interface signals and performs the following operating modes: • Straight-exits paper to the upper tray. • Punch and straight-stops paper at the leading edge, punches it, and exits it to the upper tray. • Invert-sends paper to the accumulator, and exits it to the lower tray. • Punch and invert-stops paper at the leading edge, punches it, and sends it to the accumulator where it exits to the lower tray. • Invert and staple-jogs each sheet of paper in the accumulator. When the accumulated number of sheets reaches a designated number, it staples a batch of sheets, and then exits the stapled set to the lower tray. • Punch, invert and staple-stops paper at the leading edge, punches it, sends it to the accumulator and jogs each sheet. When the accumulated number of sheets reaches a designated number, the batch is stapled, and exited to the lower tray. • Invert and offset-jogs each paper in the accumulator, shifts it by the offset, then exits it to the lower tray. • Punch, invert and offset-stops paper at the leading edge, punches it, sends it to accumulator and jogs each page, offsets it, and then exits it to the lower tray. Note: Capacity is up to 100 sheets of 20 lb paper in tray 1 (top tray) up to 1000 sheets of 20 lb paper in tray 2 (lower tray). Diagnostic aids 3-61