Lexmark WinWriter 150c Service Manual - Page 24
Print Quality Service Check, Test on Maintenance Station Service Check on,
View all Lexmark WinWriter 150c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
4077-001 Print Quality Service Check FRU 1 Print Cartridge 2 Printhead Carrier Assembly 3 System Board Printhead Cable Rubber Backer Action Be sure the machine contains good print cartridges. Reseat the printhead cables in the system board and check the following parts for wear or damage: • Print Cartridge Latch • Latch Spring • Carrier • Perform the "Test Page" on page 19. Look for a break in the diagonal line of the test pattern. A broken line indicates one or more print nozzles are not working. Run the test again to verify the failure. If there are even breaks in the diagonal line similar to the pattern shown below, replace the system board. 4 Maintenance Station If there is a single break or random breaks in the diagonal line check the following: • Check the gold-plated contacts, on the end of the cable that connect to the carrier, for dirt and wear. Use only a clean dry cloth to clean the contacts. Also check the cable for damage. You may need to remove the cable from the carrier to inspect it. • A worn rubber backer results in poor contact between the printhead cable and the print cartridge. Check the rubber backer for wear. Intermittent nozzle failures can be caused by worn parts in the maintenance station. Perform the "Maintenance Station Service Check" on page 9, then return to this check. 15