Linksys WIP300 User Guide - Page 64
Enable, Save Settings, The power LED does not light up. - reset
UPC - 745883569335
View all Linksys WIP300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
8. Repeat steps 5-7 until you have entered all four port ranges for the IP Phone. Application Internet phone 1 Internet phone 2 Internet phone 3 Internet phone 4 Start and End 5060 to 5061 53 to 53 69 to 69 10000 to 20000 Protocol UDP UDP UDP UDP IP Address (IP address of IP Phone) (IP address of IP Phone) (IP address of IP Phone) (IP address of IP Phone) Enable X X X X 9. Check the Enable option for the port services you want to use. 10. When you have completed the configuration, click the Save Settings button. 4. The power LED does not light up. Go through this checklist until your problem is solved: • Remove the IP Phone's battery from its compartment. Wait five seconds while the IP Phone resets itself. Insert the battery and power on the IP Phone. • You may be using the wrong power adapter. Make sure the power adapter you are using is the one included with the IP Phone. Wireless-G IP Phone Appendix A: Troubleshooting 55 Common Problems and Solutions