Makita LS1016L Owners Manual - Page 17
Example
View all Makita LS1016L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Table (B) Molding position in Fig. A Molding edge against guide fence Finished piece For inside (1) Wall contact edge should be against guide fence. Finished piece will be on the corner Right side of (2) blade. Ceiling contact edge should For outside be against guide fence. (3) Finished piece will be on the corner (4) Wall contact edge should be Left side of against guide fence. blade. 006364 Example: In the case of cutting 52/38° type crown molding for position (1) in Fig. A: • Tilt and secure bevel angle setting to 33.9° RIGHT. • Adjust and secure miter angle setting to 31.6° RIGHT. • Lay crown molding with its broad back (hidden) surface down on the turn base with its WALL CONTACT EDGE against the guide fence on the saw. • The finished piece to be used will always be on the RIGHT side of the blade after the cut has been made. 17