Makita LS1016L Owners Manual - Page 24
Accessories - replacement parts
View all Makita LS1016L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Cleaning the laser light lens For model LS1016L only 1. Screwdriver 2. Screw (one piece only) 3. Lens for the 1 laser light 2 3 Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 1. Screwdriver 1 2. Brush holder cap 2 009609 If the lens for the laser light becomes dirty, or sawdust adheres to it in such a way that the laser line is no longer easily visible, unplug the saw and remove and clean the lens for the laser light carefully with a damp, soft cloth. Do not use solvents or any petroleum-based cleaners on the lens. 1. Lens for the laser light 1 009610 To remove the lens for the laser light, remove the saw blade before removing the lens according to the instructions in the section titled "Installing or removing saw blade". Loosen but do not remove the screw which secures the lens using a screwdriver. Pull out the lens as shown in the figure. NOTE: • If the lens does not come out, loosen the screw further and pull out the lens again without removing the screw. Replacing carbon brushes 1. Limit mark 1 009516 After replacing brushes, plug in the tool and break in brushes by running tool with no load for about 10 minutes. Then check the tool while running and electric brake operation when releasing the switch trigger. If the electric brake is not working correctly, have the tool repaired by a Makita service center After use • After use, wipe off chips and dust adhering to the tool with a cloth or the like. Keep the blade guard clean according to the directions in the previously covered section titled "Blade guard". Lubricate the sliding portions with machine oil to prevent rust. • When storing the tool, pull the carriage toward you fully so that the slide pole is thoroughly inserted into the turn base. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. ACCESSORIES WARNING: • These Makita accessories or attachments are recommended for use with your Makita tool spcified in this manual. The use of any other accessories or attachments may result in serious personal injury. • Only use the Makita accessory or attachment for its stated purpose. Misuse of an accessory or attachment may result in serious personal injury. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. • Steel & Carbide-tipped saw blades 001145 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. 24