Marantz NA7004 NA7004 User Manual - English - Page 13

[Using the remote controller] Press the M-DAX button. Each time this button is pressed, M-DAX changes as follows. Off Low Mid High The "M-DAX" indicator on the front display lights when M-DAX mode is Low, Mid or High. (vpage 28) Operations possible during playback Setting the digital output Set to output from the rear panel DIGITAL OUT terminal (COAXIAL, OPTICAL). During stop mode, press [DIG. OUT]. Each time [DIG.OUT] is pressed, output from the DIGITAL OUT terminal (COAXIAL, OPTICAL) on the rear panel is switched between "On" and "Off". NOTE M-DAX is compatible with PCM (48 kHz or lower), MP3, WMA, AAC and two-channel analog sources. [Selectable items] On : Outputs the digital signal. Off : Digital signal is not output. Switching the display's brightness Press [DIMMER]. 100% 75% Off 25% 50% • The display's brightness switches each time the button is pressed. • If you operate the buttons when the display's brightness is set to "Off", the display temporarily lights at 25% brightness level. • The "DISPLAY OFF" indicator on the front display lights when Dimmer is set to "Off". • When digital output is turned off, the "DIG.OUT OFF" indicator lights. • When digital output is turned off, you can enjoy high quality audio output from the ANALOG OUT terminal. • The "digital output off" has a memory retention function where the settings remain stored and unchanged even when the power is turned off. Listening with headphones Plug the headphones into the headphone jack (PHONES). Adjusting the Volume Turn . NOTE To prevent hearing loss, do not raise the volume level excessively when using headphones. ENGLISH 10 Getting Started Connections Basic Operations Advanced Operations Information Explanation terms Troubleshooting Specifications Index