Marantz SR5003 SR5003 User Manual - English - Page 14
Connecting Speakers
View all Marantz SR5003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
NAMES AND FUNCTION BASIC CONNECTIONS BASIC OPERATION CONNECTING SPEAKERS Powered subwoofer FRONT A Right Left FRONT B Right Left Surround BACK Right Left FM (75Ω) GND AM ANTENNA INPUT 1(TV) INPUT 2(DVD) INPUT 3(VCR) OUTPUT L SL C SBL ZONE A TV DVD L VCR DSS R R (AUX 2) SR SW 7.1CH INPUT SBR RS-232C SPEAKER C OFF ON OUT IN OUT TAPE IN OUT VIDEO INPUT 1(TV) S-VIDEO AUDIO CD/CDR TV(1) 4 DVD(2) VCR IN(3) VCR OUT DSS(4) MONITOR OUT Y CB/PB CR/PR DIGITAL IN DIGITAL FLASHER IN REMOTE CONT. REC/ZONE B INPUT 2(DVD) SIRIUS IN 5 IN OUT 1 2 3 OUT DC OUT OUT AC OUTLETS 120V 60Hz INPUT 3(VCR) COMPONENT VIDEO Y CB/PB CR/PR OUTPUT 1 Y CB/PB CR/PR OUTPUT 2 L SL C SBL R L R L R L R L UNSWITCHED 1.25A 150W MODEL NO. SR5003 FRONT A FRONT B SURROUND R SR SW SBR FRONT A OR B,CENTER, SURR,SURR BACK : 6-8 OHMS FRONT A + B : 8 OHMS SPEAKER SYSTEMS PRE OUT CENTER SURROUND BACK SPEAKER C/ ZONE SPEAKER A SWITCHED 1.25A 150W AC IN Right Left Surround Center ENGLISH CONNECTING SPEAKER WIRE 1. Strip away approx. 3/8 inch (10 mm) of wire insulation. 2. Twist the bared wire ends tight, to prevent short circuits. 3. Loosen the knob by turning it counterclockwise. 4. Insert the bare part of the wire into the hole in side of each terminal. 5. Tighten the knob by turning it clockwise to secure the wire. 1. 2. 3/8 inch (10 mm) 3. 4. 5. Caution: • Be sure to use speakers with the specified impedance as shown on the rear panel of this unit. • To prevent damage to circuitry, do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. • Do not touch the speaker terminals when the power is on. It may cause you to receive an electric shocks. • Do not connect more than one speaker cable to one speaker terminal. Doing so may damage this unit. Note: • Be sure to connect the positive and negative cables for the speaker properly. If they are miss-connected, the signal phase will be reversed and the signal quality will be corrupted. CONNECTING A SUBWOOFER Use the PRE OUT SUBWOOFER jack to connect a powered subwoofer (power amplifier built in ). ADVANCED CONNECTIONS SETUP ADVANCED OPERATION TROUBLESHOOTING OTHERS 11