Marantz SR5003 SR5003 User Manual - English - Page 64
Operation Of The Multi Zone Outputs
View all Marantz SR5003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
NAMES AND FUNCTION BASIC CONNECTIONS BASIC OPERATION ADVANCED CONNECTIONS ENGLISH OPERATION OF THE MULTI ZONE OUTPUTS WITH THE REMOTE CONTROL FROM ZONE A The following operations can be performed when using an RC101 remote controller (sold separately). CHANGE THE ZONE CONTROL COMMANDS (RC101) FOR ZONE A ZONE A output can be operated from a room where the unit is not installed. This requires a separately sold IR receiver. (For connections, see page 21.) (When operating the unit by Multi ZONE connected) • ZONE A: ZONE A Control (Default) • ZONE B: ZONE B Control Change the control commands for each ZONE. 2. 1. 1. Press SET button and ZONE button until the SEND indicator blinks twice. Then backlight flashes. 2. Press A ZONE button. When the procedure is successful, the SEND indicator will blink twice. Notes for the Multi ZONE System • If the Tuner (FM or AM) is active in the main ZONE, you can not control any function of the tuner. In this case, You must listen to the same station as the main ZONE. OPERATION OF THE MULTI ZONE OUTPUTS WITH THE REMOTE CONTROL FROM ZONE B The following operations can be performed when using an RC101 remote controller (sold separately). CHANGE THE ZONE CONTROL COMMANDS (RC101) FOR ZONE B ZONE B output can be operated from a room where the unit is not installed. This requires a separately sold IR receiver. (For connections, see page 21.) Change the control commands for each ZONE. 2. 1. 1. Press SET button and ZONE button until the SEND indicator blinks twice. Then backlight flashes. 2. Press B ZONE button. When the procedure is successful, the SEND indicator will blink twice. These buttons change a special code of each ZONE. OPERATION OF THE ZONE SPEAKER OUTPUTS WITH THE REMOTE CONTROL To switch to ZONE SPEAKER SYSTEM A control, perform the following operations with the RC101 set to ZONE A. 1. 3. 2. 1. 1. Press SET button and POWER ON button until the SEND indicator blinks twice. Then backlight flashes. 2. Press the DVD button. Note Press the TV button at this time to return to the ZONE settings. 3. Press ENTER button once to lock in the code. When the procedure is successful, the SEND indicator will blink twice. These buttons change a special code of each ZONE. POWER ON/OFF POWER ON/OFF SOURCE VOL +/- MUTE SOURCE SETUP ADVANCED OPERATION TROUBLESHOOTING OTHERS 61