Netgear GSM5212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 134

ProSafe Managed Switch Term Definition Mbr Ports A listing of the ports that are members of this port-channel (LAG), in unit/slot/port notation. There can be a maximum of eight ports assigned to a given port-channel (LAG). Device Timeout For each port, lists the timeout (long or short) for Device Type (actor or partner). Port Speed Speed of the port-channel port. Ports Active This field lists ports that are actively participating in the port-channel (LAG). Load Balance Option The load balance option associated with this LAG. See port-channel load-balance on page 129. show port-channel system priority Use this command to display the port-channel system priority. Format Mode show port-channel system priority Privileged EXEC Port Mirroring Port mirroring, which is also known as port monitoring, selects network traffic that you can analyze with a network analyzer, such as a SwitchProbe device or other Remote Monitoring (RMON) probe. monitor session This command configures a probe port and a monitored port for monitor session (port monitoring). Use the source interface parameter to specify the interface to monitor. Use rx to monitor only ingress packets, or use tx to monitor only egress packets. If you do not specify an {rx | tx} option, the destination port monitors both ingress and egress packets. Use the destination interface to specify the interface to receive the monitored traffic. Use the mode parameter to enabled the administrative mode of the session. If enabled, the probe port monitors all the traffic received and transmitted on the physical monitored port. Format Mode monitor session {source interface [{rx | tx}] | destination interface | mode} Global Config no monitor session Use this command without optional parameters to remove the monitor session (port monitoring) designation from the source probe port, the destination monitored port and all VLANs. Once the port is removed from the VLAN, you must manually add the port to any desired VLANs. Use the source interface parameter or Switching Commands 134