Netgear GSM5212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 682

ProSafe Managed Switch Table 42. Routing Table Manager Log Messages Component Routing Table Manager Routing Table Manager Message Cause RTO is full. Routing table contains 8000 best routes, 8000 total routes. The routing table manager, also called "RTO," stores a limited number of best routes, based on hardware capacity. When the routing table becomes full, RTO logs this alert. The count of total routes includes alternate routes, which are not installed in hardware. RTO no longer full. Bad adds: 10. Routing table contains 7999 best routes, 7999 total routes. When the number of best routes drops below full capacity, RTO logs this notice. The number of bad adds may give an indication of the number of route adds that failed while RTO was full, but a full routing table is only one reason why this count is incremented. Table 43. VRRP Log Messages Component VRRP VRRP VRRP Message Changing priority to 255 for virtual router with VRID 1 on interface 1/0/1 Changing priority to 100 for virtual router with VRID 1 on interface 1/0/1 vrrpPacketValidate: Invalid TTL Cause When the router is configured with the address being used as the virtual router ID, the router's priority is automatically set to the maximum value to ensure that the address owner becomes the VRRP master. When the router is no longer the address owner, Switch CLI reverts the router's priority to the default. VRRP ignored an incoming message whose time to live (TTL) in the IP header was not 255. Table 44. ARP Log Message Component ARP Message Cause ARP received mapping for IP address xxx to MAC address yyy. This IP address may be configured on two stations. When we receive an ARP response with different MAC address from another station with the same IP address as ours. This might be a case of misconfiguration. Log Messages 682