Netgear GSM5212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 19

ProSafe Managed Switch Table 8. CLI Editing Conventions (Continued) Key Sequence Ctrl-Y Ctrl-Q Ctrl-S Ctrl-Z Tab, Exit ? Description Prints last deleted character Enables serial flow Disables serial flow Return to root command prompt Command-line completion Go to next lower command prompt List available commands, keywords, or parameters Using CLI Help Enter a question mark (?) at the command prompt to display the commands available in the current mode. (switch) >? enable help logout ping quit show telnet Enter into user privilege mode. Display help for various special keys. Exit this session. Any unsaved changes are lost. Send ICMP echo packets to a specified IP address. Exit this session. Any unsaved changes are lost. Display Switch Options and Settings. Telnet to a remote host. Enter a question mark (?) after each word you enter to display available command keywords or parameters. (switch) #network ? javamode mgmt_vlan parms protocol Enable/Disable. Configure the Management VLAN ID of the switch. Configure Network Parameters of the router. Select DHCP, BootP, or None as the network config protocol. If the help output shows a parameter in angle brackets, you must replace the parameter with a value. (switch) #network parms ? Enter the IP address. If there are no additional command keywords or parameters, or if additional parameters are optional, the following message appears in the output: Press Enter to execute the command Using the Command-Line Interface 19