Netgear GSM5212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 502

ProSafe Managed Switch Auto Install Commands This section describes the Auto Install Commands. Auto Install is a software feature which provides for the configuration of a switch automatically when the device is initialized and no configuration file is found on the switch. The Auto Install process requires DHCP to be enabled by default in order for it to be completed. The downloaded config file is not automatically saved to startup-config. An administrator must explicitly issue a save request in order to save the configuration. The Auto Install process depends upon the configuration of other devices in the network, including a DHCP or BOOTP server, a TFTP server and, if necessary, a DNS server. There are three steps to Auto Install: 1. Configuration or assignment of an IP address for the device. 2. Assignment of a TFTP server. 3. Obtain a configuration file for the device from the TFTP server. show autoinstall This command displays the current status of the Auto Config process. Format Mode show autoinstall Privileged EXEC Term AutoInstall Mode AutoSave Modet AutoInstall Retry Count AutoInstall State Definition The administrator mode is enabled or disabled. If this option is enabled, the downloaded config file will be saved. Otherwise, administrator must explicitly issue a "copy running-config startup-config" command in order to save the configuration. the number of attempts to download a configuration. The status of the AutoInstall. Example (switch) #show autoinstall AutoInstall Mode Stopped AutoSave Mode Disabled AutoInstall Persistant Mode Enabled AutoInstall Retry Count 3 AutoInstall State Waiting for boot options Utility Commands 502