Netgear GSM5212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 292

ProSafe Managed Switch Term Definition Always Shows whether default routes are always advertised. Metric The metric of the routes being redistributed. If the metric is not configured, this field is blank. Metric Type Shows whether the routes are External Type 1 or External Type 2. Number of Active Areas The number of active OSPF areas. An "active" OSPF area is an area with at least one interface up. AutoCost Ref BW Shows the value of auto-cost reference bandwidth configured on the router. Maximum Paths The maximum number of paths that OSPF can report for a given destination. Redistributing This field is a heading and appears only if you configure the system to take routes learned from a non-OSPF source and advertise them to its peers. Source The source protocol/routes that are being redistributed. Possible values are static, connected, or RIP. Tag The decimal value attached to each external route. Subnets For redistributing routes into OSPF, the scope of redistribution for the specified protocol. Distribute-List The access list used to filter redistributed routes. The following shows example CLI display output for the command. (Switch) #show ip ospf Router ID 2.2.2.2 OSPF Admin Mode Disable RFC 1583 Compatibility Enable External LSDB Limit No Limit Exit Overflow Interval 0 Spf Delay Time 5 Spf Hold Time 10 Opaque Capability Disable AutoCost Ref BW 100 Mbps Default Passive Setting Disabled Maximum Paths 4 Default Metric Not configured Default Route Advertise Disabled Always FALSE Metric Not configured Metric Type External Type 2 Number of Active Areas 3 (3 normal, 0 stub, 0 nssa) ABR Status Disable ASBR Status Disable Stub Router FALSE External LSDB Overflow FALSE Routing Commands 292