Netgear GSM5212P GSM5212P/GSM7212P/GSM7212F/GSM7224P CLI Manual - Page 247

ProSafe Managed Switch Term Netdir Bcast MultiCast Fwd Definition Indicates if IP forwards net-directed broadcasts on this interface. Possible values are Enable or Disable. The multicast forwarding administrative mode on the interface. Possible values are Enable or Disable. show ip route This command displays the routing table. The specifies the network for which the route is to be displayed and displays the best matching best-route for the address. The specifies the subnet mask for the given . When you use the longer-prefixes keyword, the and pair becomes the prefix, and the command displays the routes to the addresses that match that prefix. Use the parameter to specify the protocol that installed the routes. The value for can be connected, ospf, rip, or static. Use the all parameter to display all routes including best and non-best routes. If you do not use the all parameter, the command only displays the best route. Note: If you use the connected keyword for , the all option is not available because there are no best or non-best connected routes. Format Modes show ip route [{ [] | { [longer-prefixes] [] | } [all] | all}] • Privileged EXEC • User EXEC Term Route Codes Definition The key for the routing protocol codes that might appear in the routing table output. The show ip route command displays the routing tables in the following format: Code IP-Address/Mask [Preference/Metric] via Next-Hop, Route-Timestamp, Interface The columns for the routing table display the following information: Term Code IP-Address/Mask Preference Definition The codes for the routing protocols that created the routes. The IP-Address and mask of the destination network corresponding to this route. The administrative distance associated with this route. Routes with low values are preferred over routes with higher values. Routing Commands 247