Netgear XCM8810 Chassis User Manual - Page 136

NETGEAR 8800 User Manual logical port serves as the LAG Group ID. VLANs configured to use other ports in the load-sharing group will have those ports deleted from the VLAN when load sharing becomes enabled. Cross-Module Load Sharing on a NETGEAR 8800 Switch The following example defines a static load-sharing group on modular switches that contains ports 9 through 12 on slot 3, ports 7 through 10 on slot 5, and uses port 7 in the slot 5 group as the primary logical port, or LAG Group ID: enable sharing 5:7 grouping 3:9-3:12, 5:7-5:10 In this example, logical port 5:7 represents physical ports 3:9 through 3:12 and 5:7 through 5:10. When using load sharing, you should always reference the LAG Group ID of the load-sharing group (port 5:7 in the previous example) when configuring or viewing VLANs. VLANs configured to use other ports in the load-sharing group will have those ports deleted from the VLAN when load sharing becomes enabled. Address-based load sharing can also span modules. Single-Module Load Sharing on a NETGEAR 8800 Switch The following example defines a static load-sharing, or link aggregation, group that contains ports 9 through 12 on slot 3 and uses the first port as the master logical port 9, or LAG group ID: enable sharing 3:9 grouping 3:9-3:12 In this example, logical port 3:9 represents physical ports 3:9 through 3:12. LACP Example The following configuration example: • Creates a dynamic LAG with the logical port (LAG Group ID) of 10 that contains ports 10 through 12. • Sets the system priority for that LAG to 3. • Adds port 5 to the LAG. enable sharing 10 grouping 10-12 lacp configure sharing 10 lacp system-priority 3 configure sharing 10 add port 5 Health Check LAG Example The following example creates a Health Check LAG of 4 ports: create vlan v1 configure v1 ip 192.168.1.1/24 enable sharing 5 grouping 5-8 health-check 136 | Chapter 5. Configuring Slots and Ports on a Switch