Netgear XCM8810 Chassis User Manual - Page 873

NETGEAR 8800 User Manual Table/Group PIM Traps Supported Variables pimSourceLifetime pimStateRefreshInterval pimStateRefreshLimitInterval pimStateRefreshTimeToLive pimNeighborLoss Comments State Refresh feature is not supported, so these variables are set to defaults. Not supported. SNMPv3 MIBs The XCM8800 SNMP stack fully supports the SNMPv3 protocol and therefore implements the MIBs in the SNMPv3 RFCs. Specifically, the MIBs in the following RFCs are fully supported. • RFC 3410 - Introduction and Applicability Statements for Internet-Standard Management Framework • RFC 3411 - An Architecture for Describing Simple Network Management Protocol (SNMP) Management Frameworks • RFC 3412 - Message Processing and Dispatching for the Simple Network Management Protocol (SNMP) • RFC 3413 - Simple Network Management Protocol (SNMP) Applications. • RFC 3414 - User-based Security Model (USM) for version 3 of the Simple Network Management Protocol (SNMPv3) • RFC 3415 - View-based Access Control Model (VACM) for the Simple Network Management Protocol (SNMP) • RFC 2576 - Coexistence between Version 1, Version 2, and Version 3 of the Internet-standard Network Management Framework • RFC 3826 - The Advanced Encryption Standard (AES) Cipher Algorithm in the SNMP User-based Security Model RFC 2737 (ENTITY-MIB) The following tables, groups, and variables are supported in this MIB. Table/Group entityPhysicalTable Supported Variables entPhysicalndex entPhysicalDescr entPhysicalVendorType entPhysicalContainedIn entPhysicalClass Comments Appendix D. Supported Protocols, MIBs, and Standards | 873