Netgear XCM8810 Chassis User Manual - Page 906

NETGEAR 8800 User Manual Table/Group Supported Variables netgearVlanOpaqueControlTable All objects netgearVlanStackTable netgearVlanL2StatsTable All objects All objects Comments For all tables in this MIB that contain objects with RowStatus semantics, the only values supported are: {active, createAndGo, destroy}. New to XCM8800: netgearVlanOpaqueControlTable is a write only table and cannot be used to read. This is used to add/delete ports on a VLAN. Not supported. Not supported.  This table contains per VLAN information about the number of packets sent to the CPU, the number of packets learnt, the number of Igmp control packets snooped and the number of Igmp data packets switched. This is the same information that is available via the CLI command 'show l2stats'. NETGEAR-PORT-MIB The following tables, groups, and variables are supported in this MIB. Table/Group netgearPortLoadshareTable netgearPortSummitlinkTable netgearPortLoadshare2Table Supported Variables Comments All objects Not supported All objects Not supported. netgearPortLoadshare2Entry A table of bindings between a master port and its load-sharing slaves: create/delete entries here to add/delete a port to/from a load-sharing group. Default is empty table. There are restrictions on what row creates will be accepted by each device. netgearPortLoadshare2MasterIfIndex The ifIndex value which identifies the port controlling a load-sharing group of ports which includes netgearPortLoadshareSlaveI fIndex. 906 | Appendix D. Supported Protocols, MIBs, and Standards