Netgear XCM8810 Chassis User Manual - Page 631

NETGEAR 8800 User Manual entry two { if match all { destination-port 67 ; } then { vlan "to7" ; } } If you include more than one VLAN set attribute or more than one destination-ipaddress set attribute in one policy entry, the last one is accepted and the rest are ignored. Note: Although the Policy manager allows you to set a range for the destination-port, you should not specify the range for the destination-port attribute in the match clause of the policy statement for the UDP profile. If a destination-port range is configured, the last port in the range is accepted and the rest are ignored. You can have two valid set statements in each entry of a UDP Forwarding policy; one a destination-ipaddress and one a VLAN. XCM8800 currently allows a maximum of eight entries in a UDP Forwarding policy, so you can define a maximum of 16 destinations for one inbound broadcast UDP packet: eight IP addresses and eight VLANs. Note: It is strongly advised to have no more than eight entries in a UDP Forwarding profile. The UDP Forwarding module processes those entries even if the entries do not contain any attributes for UDP Forwarding. Having more than eight entries drastically reduces the performance of the system. If the inbound UDP traffic rate is very high, having more than eight entries could cause the system to freeze or become locked. Note: If you rename a VLAN referred to in your UDP Forwarding profile, you must manually edit the policy to reflect the new name, and refresh the policy. You can also validate whether the UDP profile has been successfully associated with the VLAN by using the command show policy { | detail}. UDP Forwarding is implemented as part of the netTools process, so the command does display netTools as a user of the policy. To remove a policy, use the none form of the following command: Chapter 20. IPv4 Unicast Routing | 631