Netgear XCM8810 Chassis User Manual - Page 835

NETGEAR 8800 User Manual • General Tips and Recommendations on page 835 • MSM Prompt on page 837 • Command Prompt on page 837 • Port Configuration on page 837 • Software License Error Messages on page 838 • VLANs on page 839 • STP on page 840 • VRRP on page 840 General Tips and Recommendations The initial welcome prompt does not display: Check that: • Your terminal or terminal emulator is correctly configured • Your terminal or terminal emulator has the correct settings: • 9600 baud • 8 data bits • 1 stop bit • no parity • XON/OFF flow control enabled For console port access, you may need to press [Return] several times before the welcome prompt appears. The SNMP Network Manager cannot access the device: Check that: • The Simple Network Management Protocol (SNMP) access is enabled for the system. • The device IP address, subnet mask, and default router are correctly configured, and that the device has been reset. • The device IP address is correctly recorded by the SNMP Network Manager (see the user documentation for the Network Manager). • The community strings configured for the system and Network Manager are the same. • The SNMPv3 USM, Auth, and VACM configured for the system and Network Manager are the same. The Telnet workstation cannot access the device: Check that: • The device IP address, subnet mask, and default router are correctly configured, and that the device has been reset. • You entered the IP address of the switch correctly when invoking the Telnet facility. Appendix C. Troubleshooting | 835