Netgear XCM8810 Chassis User Manual - Page 250

NETGEAR 8800 User Manual create vlan development configure development ipaddress 2001:0DB8::8:800:200C:417A/64 configure default delete port 1-3 configure development add port 1-3 The following modular switch example creates a protocol-based VLAN named ipsales. Slot 5, ports 6 through 8, and slot 6, ports 1, 3, and 4-6 are assigned to the VLAN. In this example, you can add untagged ports to a new VLAN without first deleting them from the default VLAN, because the new VLAN uses a protocol other than the default protocol. create vlan ipsales configure ipsales protocol ip configure ipsales add port 5:6-5:8,6:1,6:3-6:6 The following modular switch example defines a protocol filter, myprotocol and applies it to the VLAN named myvlan. This is an example only, and has no real-world application. create protocol myprotocol configure protocol myprotocol add etype 0xf0f0 configure protocol myprotocol add etype 0xffff create vlan myvlan configure myvlan protocol myprotocol To disable the protocol-based VLAN (or any VLAN) in the above example, use the following command: disable vlan myprotocol To re-enable the VLAN, use the following command: enable vlan myprotocol To display VLAN settings, use the following command: show vlan {detail {ipv4 | ipv6} | {ipv4 | ipv6} | virtual-router | stpd | security} The show command displays information about each VLAN, which includes: • Name • VLANid • Enabled or disabled • How the VLAN was created • Primary IPv4 address • Secondary IP address (if configured) • IPv6 addresses (if configured) • Virtual router that VLAN belongs with • IPX address (if configured). • STPD information 250 | Chapter 9. VLANs