Netgear XCM8810 Chassis User Manual - Page 818

NETGEAR 8800 User Manual Note: Configuration files have a .cfg file extension. When you enter the name of the file in the CLI, the system automatically adds the .cfg file extension. If you have made a mistake or you must revert to the configuration as it was before you started making changes, you can tell the switch to use the backup configuration on the next reboot. Each filename must be unique and can be up to 32 characters long. Filenames are also case sensitive. For information on filename restrictions, see the specific command in the NETGEAR 8800 Chassis Switch CLI Manual. To save the configuration, use the following command: save configuration {primary | secondary | | } Where the following is true: • primary-Specifies the primary saved configuration • secondary-Specifies the secondary saved configuration • existing-config-Specifies an existing user-defined configuration (displays a list of available user-defined configuration files) • new-config-Specifies a new user-defined configuration You are then prompted to save the changes. Enter y to save the changes or n to cancel the process. To use the configuration, use the following command: use configuration [primary | secondary | ] Where the following is true: • primary-Specifies the primary saved configuration • secondary-Specifies the secondary saved configuration • file_name-Specifies an existing user-defined configuration (displays a list of available user-defined configuration files) The configuration takes effect on the next reboot. Note: If the switch is rebooted while in the middle of saving a configuration, the switch boots to factory default settings if the previously saved configuration file is overwritten. The configuration that is not in the process of being saved is unaffected. This section contains the following topics: 818 | Appendix B. Software Upgrade and Boot Options