Netgear XCM8810 Chassis User Manual - Page 379

NETGEAR 8800 User Manual Note: You cannot configure the priority for the QoS profile on NETGEAR 8800 switches. To remove the limit on egress bandwidth per QoS profile per port, re-issue this command using the default values. To display the current configuration for the QoS profile, use the following command: show qosprofile {ingress | egress} ports [ all | ] Configuring Egress Port Rate Limits The following section describes egress port rate limiting on the NETGEAR 8800. Configuration on NETGEAR 8800 Switches The default behavior is to have no limit on the egress traffic per port. To configure egress rate limiting, use the following command: configure ports rate-limit egress [no-limit | [Kbps | Mbps | Gbps] {max-burst-size [Kb | Mb]}] To view the configured egress port rate-limiting behavior, use the following command: show ports {mgmt | } information {detail} You must use the detail parameter to display the egress port rate configuration and, if configured, the maximum burst size. See Displaying Port Information on page 148 for more information on the show ports information command. You can also display this information using the following command: show configuration vlan The following is sample output from the show configuration vlan command for configured egress rate limiting: # Module vlan configuration. # configure vlan Default tag 1 config port 3:1 rate-limit egress 128 Kbps max-burst-size 200 Kb config port 3:2 rate-limit egress 128 Kbps config port 3:10 rate-limit egress 73 Kbps max-burst-size 128 Kb configure vlan Default add ports 3:1-48 untagged Note: See Chapter 10, FDB for more information on limiting broadcast, multicast, or unknown MAC traffic ingressing the port. Chapter 15. QoS | 379