Netgear XCM8810 Chassis User Manual - Page 773

NETGEAR 8800 User Manual In the topology, loopback VLANs are configured on each of the switches and the loopback addresses for each of the switches are as follows: • MSDP 1 (10.1.1.1/32) • MSDP 2 (10.1.1.2/32) • MSDP 3 (10.1.1.3/32) Note: The autonomous system (AS) number for the peer is used in peer-RPF checks. The AS number provided by the user is treated as the AS number in which the peer resides. If you do not specify an AS number, BGP is used to determine the AS number for the peer. If the peer is reachable by other routes, BGP will not be able to determine the AS number for the peer. The following sections provide additional information on the MSDP configuration portion of this example: • Switch MSDP1 Configuration Commands on page 773 • Switch MSDP2 Configuration Commands on page 774 • Switch MSDP3 Configuration Commands on page 774 Note: For an example of the VLAN and PIM configuration that supports MSDP in this example, see the next example, Configuring Anycast RP on page 775, which is similar to this example. Switch MSDP1 Configuration Commands The following is an example MSDP configuration for switch MSDP1: create msdp peer 10.0.1.2 configure msdp peer 10.0.1.2 decription "msdp_22" configure msdp peer 10.0.1.2 password "test" create msdp peer 10.0.3.3 configure msdp peer 10.0.3.3 password "test" configure msdp peer 10.0.3.3 desciption "msdp_13" create msdp mesh-group m1 configure msdp peer 10.0.1.2 mesh-group m1 configure msdp peer 10.0.3.3 mesh-group m1 configure msdp originator-id 10.0.1.1 /To configure unique originator id Chapter 29. MSDP | 773