Olympus MAUSB-100 Reference Manual - Page 41

format, click OK. To quit, click Cancel.] appears.

Get Olympus MAUSB-100 PDF manuals and user guides View all Olympus MAUSB-100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

3. Click [Check xD]. [The card is ready.] appears if the xD-Picture Card is recognized by the computer. ● If an xD-Picture card is not already inserted in the MAUSB-100, a warning message saying [Insert xDPicture card.] appears. 4. Click [Format xD]. A warning message saying [Formatting will erase all data on this card! To format, click OK. To quit, click Cancel.] appears. To format the card, click [OK]. ● The red status lamp lights while the card is being formatted. NEVER remove the card or disconnect the MAUSB-100 from the computer when the red status lamp is lit. 5. When formatting is complete, [Format completed.] appears. ● If the MAUSB-100's write-protect switch is set to ON, the card cannot be formatted and a warning message saying [This card is protected.] appears. 6. Click [Exit] to close [xDFormat]. ● If you want to use the card after formatting, be sure to close the utility software [xDFormat] first. ● Be sure to close the utility software [xDFormat] before removing the card or disconnecting the MAUSB-100 from the computer. 41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
41
3.
Click [Check xD]. [The card is ready.] appears if
the xD-Picture Card is recognized by the
computer.
●
If an xD-Picture card is not already inserted in the
MAUSB-100, a warning message saying [Insert xD-
Picture card.] appears.
4.
Click [Format xD]. A warning message saying
[Formatting will erase all data on this card! To
format, click OK. To quit, click Cancel.] appears.
To format the card, click [OK].
●
The red status lamp lights while the card is being
formatted. NEVER remove the card or disconnect
the MAUSB-100 from the computer when the red
status lamp is lit.
5.
When formatting is complete,
[Format
completed.] appears.
●
If the MAUSB-100's write-protect switch is set to
ON, the card cannot be formatted and a warning
message saying [This card is protected.] appears.
6.
Click [Exit] to close [xDFormat].
●
If you want to use the card after formatting, be sure
to close the utility software [xDFormat] first.
●
Be sure to close the utility software [xDFormat]
before removing the card or disconnecting the
MAUSB-100 from the computer.