Onkyo HT-R667 Owner Manual - Page 68

Recording This section explains how to record the input source and how to record audio and video from separate sources. Notes: • The surround sound and DSP listening modes cannot be recorded. • Copy-protected DVDs cannot be recorded. • Sources connected to the multichannel DVD input cannot be recorded. • Sources connected to a digital input cannot be recorded. Only analog inputs can be recorded. • DTS signals will be recorded as noise, so don't attempt analog recording of DTS CDs or LDs. Recording the Input Source Audio sources can be recorded to a recorder (e.g., cassette deck, CDR, MD) connected to the TAPE OUT jack. Video sources can be recorded to a video recorder (e.g., VCR, DVR) connected to the VCR/DVR OUT jacks. See pages 26 to 40 for hookup information. 1 Use the input selector buttons to select the source that you want to record. DVD VCR/DVR CBL/SAT See "Which Connections Should I Use?" on page 27 to see which signals AUX TAPE TUNER can be output and recorded. CD Remote controller You can watch the source while recording it. The AV receiver's MASTER VOLUME control has no effect on recording. Recording from Different AV Sources You can overdub audio onto your video recordings by simultaneously recording audio and video from two separate sources. This is possible because only the audio source is switched when an audio-only input source, such as TAPE, TUNER, or CD, is selected, the video source remains the same. In the following example, audio from the CD player connected to the CD IN and video from the camcorder connected to the AUX INPUT VIDEO jack are recorded by the VCR connected to the VCR/DVR OUT jacks. AUX INPUT VIDEO L AUDIO R Camcorder video signal audio signal IN 4 IN 3 (CBL/SAT) IN 2 HDMI ASSIGNABLE (VCR/DVR) IN 1 (DVD) OUT DIGITAL IN 1 (DVD) COAXIAL 2 (CBL/SAT) 1 (VCR/DVR) OPTICAL 2 (CD) ASSIGNABLE COMPONENT VIDEO Y CB/ PB CR/ PR IN 2 (CBL/SAT) IN 1(DVD) OUT ASSIGNABLE IN OUT IN L DOCK (for DS-A1L) CBL/SAT VCR/DVR V S DVD MONITOR OUT V S AM ANTENNA FM 75 IN IN L OUT OUT IN IN IN FRONT SURR CENTER SURR BACK L REMOTE CONTROL R CD TAPE R CBL/SAT VCR/DVR R SUB WOOFER DVD CD player VCR 2 On your recorder, start record- ing. 3 On the source component, start playback. Note: • If you select a different input source during recording, that input source will be recorded instead. 1 Prepare the camcorder and CD player for playback. 2 Prepare the VCR for recording. 3 Press the [AUX] input selector button. 4 Press the [CD] input selector button. This selects the CD player as the audio source but leaves the camcorder as the video source. 5 Start recording on the VCR, then start playback on the camcorder and CD player. Video from the camcorder and audio from the CD player are recorded by the VCR. 68