Onkyo TX-NR3007 Owner Manual - Page 137
Adjusting the Volume for Zones, Muting Zones, Adjusting the Tone and Balance of Zones
View all Onkyo TX-NR3007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Multi Zone-Continued Notes: • Only analog input sources are output by the ZONE 2/ 3 PRE OUT and ZONE 2/3 L/R speaker terminals. Digital input sources are not output. If no sound is heard when an input source is selected, check if it's connected to an analog input. • You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room. For example, if you have an FM station for the main room, that station will also be used in Zone 2. • When you connect Zone 2 speakers directly to the AV receiver, listening modes that require front high or front wide speakers such as Dolby Pro Logic IIz Height or Audyssey Dynamic Surround Expansion™ are unavailable. • When you connect Zone 3 speakers directly to the AV receiver, listening modes that require surround back speakers such as Dolby EX, DTS-ES or THX Ultra2 Cinema are unavailable. • When the input selector of Zone 2/3 is selected, power consumption on standby mode slightly increases. • While Zone 2/3 is on, V functions will not work. Adjusting the Volume for Zones Remote controller On the remote controller, press the [ZONE] button repeatedly, and then use the VOL [R]/[X] button. AV receiver On the AV receiver, press the [ZONE 2] or [ZONE 3] button (the ZONE 2/3 indicator and Zone 2/3 selector on the display flashes) and press [LEVEL] button followed by the [F]/[S] buttons within 8 seconds. Muting Zones Remote controller On the remote controller, press the [ZONE] button repeatedly, and then press the [MUTING] button. To unmute a zone, on the remote controller, press the [ZONE] button, and then press the [MUTING] button again. Adjusting the Tone and Balance of Zones 1 AV receiver On the AV receiver, press the [ZONE 2] or [ZONE 3] button. 2 Press the AV receiver's [TONE] button repeatedly to select "Bass", "Treble" or "Balance". 3 Use the Up [S] and Down [F] buttons to adjust the bass, treble or balance. • You can boost or cut the bass or tre- ble from -10 dB to +10 dB in 2 dB steps. • You can adjust the balance from 0 in the center to +10 dB to the right or +10 dB to the left in 2 dB steps. Notes: • Zones can also be unmuted by adjusting the volume. • The volume, tone and balance functions cannot be set when the "Zone2 Out" or "Zone3 Out" setting is set to "Fixed" (page 135) and "Powered Zone2" or "Powered Zone3" setting is set to "Not Act" (page 134). • Even if you repeatedly press the remote controller's [ZONE] button to select zones, the last zone selection will be retained once you have switched to other components by pressing other REMOTE MODE buttons after pressing the [ZONE] button. 137