Onkyo TX-NR3007 Owner Manual - Page 63
Use the Up and Down, Press [ENTER].
View all Onkyo TX-NR3007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
First Time Setup-Continued • Make the room as quiet as possible. 6 Background noise can disrupt the room measurements. Close windows, silence cell phones, televisions, radios, air conditioners, 7 fluorescent lights, home appliances, light dimmers, or other devices. • Cell phones should be turned off or placed away from all audio electronics during the measurement process as Radio Frequency Interference (RFI) may cause measurement disruptions (even if the cell phone is not in use). 4 Press [ENTER]. The room correction and speaker setup starts. MultEQ XT: Auto Setup Do not unplug setup microphone. Please keep quiet. Now measuring. . . Test tones are played through each speaker as Audyssey MultEQ® XT Room Correction and Speaker Setup runs. This process takes a few minutes. Please refrain from talking during measurements and do not stand 8 between speakers and the microphone. 5 The following screen appears. MultEQ XT: Auto Setup Please place setup microphone at 2nd position at ear height. Next Place the setup microphone at the next position (page 61), and then press [ENTER]. Audyssey MultEQ XT performs more measurements. This takes a few minutes. MultEQ XT: Auto Setup Do not unplug setup microphone. Please keep quiet. Now measuring. . . When prompted, place the setup microphone at the next position, and repeat step 5. After the 3rd to the 8th measurement, the following screen appears. MultEQ XT: Auto Setup Please select [Next], when measuring next position, and select [Finish], when ending. Next Finish(Calculate) Use the Up and Down [R]/[X] buttons to select an option, and then press [ENTER]. Next: Select "Next" to begin measuring the next measurement position. After the 8th measurement has been taken, the procedure automatically proceeds to step 8. Finish(Calculate): Select this if you don't want to measure any more listening positions and are ready to calculate the results, then go to step 8. When the measurements are complete, the following screen appears. MultEQ XT: Auto Setup Calculating... 63