Onkyo TX-NR3007 Owner Manual - Page 62
Using Audyssey MultEQ, to the SETUP MIC jack. - height speaker setting
View all Onkyo TX-NR3007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
First Time Setup-Continued Using Audyssey MultEQ® XT 1 ON/STANDBY 2 Speaker setup microphone ENTER 3 RXFS Notes: • If any of your speakers is 4 ohms, change "Speaker Impedance" setting before running Audyssey MultEQ XT Room Correction and Speaker Setup (see page 57). • If the AV receiver is muted, it will be unmuted automatically when Audyssey MultEQ XT Room Correction and Speaker Setup starts. • Room correction and speaker setup can only be used with Speakers A. • Room correction and speaker setup cannot be performed while a pair of headphones is connected, or Speakers B is selected. • It takes about 30 minutes to complete the room correction and speaker setup for eight positions. Total measurement time varies depending on the number of speakers. • Do not disconnect the speaker setup microphone during the room correction and speaker setup, unless you want to cancel the setup. • Do not connect or disconnect any speakers during the room correction and speaker setup. Turn on the AV receiver and the connected TV. On the TV, select the input to which the AV receiver is connected. Set the speaker setup microphone at the Main Listening Position B (page 61), and connect it to the SETUP MIC jack. The speaker setting menu appears. MultEQ XT: Auto Setup Speakers Type(FrontA) Speakers Type(FrontB) Powered Zone2 Powered Zone3 Normal Not Use Not Act Not Act If you change these settings, refer to step 5 on "Speaker Settings" (page 57) or step 4 on "Setting the Powered Zone 2/3" (page 134). When you've finished, press the [ENTER] button. MultEQ XT: Auto Setup Please place setup microphone at center of listening area at ear height. Next Notes: • Before starting Audyssey MultEQ XT Room Correction and Speaker Setup, arrange the room and connect the speakers as you would for enjoying movies. Changes to the room after auto setup requires you run the auto setup again, as room EQ characteristics may have changed. • When starting the room correction and speaker setup, do not stand between the speakers and microphone, and avoid obstacles blocking the path between speakers and microphone. This will produce inaccurate results. • Position the microphone at ear height of a seated listener with the microphone tip pointed directly at the ceiling using a tripod. Do not hold the microphone in your hand during measurements as this will produce inacurate results. 62