Onkyo TX-NR3007 Owner Manual - Page 87

Using the Listening Modes-Continued 5.1 channel Sources (3/3) Listening Mode Button ✔: Available Listening Modes Speaker layout LH RH LH RH LH RH *1 LH *2 *1 RH *2 LW FL C FR RW LW FL C FR RW LW FL C FR RW LW FL C FR RW *1 *1 *2 *2 SW SW SW SW SW SW SW SW SL SR SL SR SL SR SL SR SBL SBR SBL SBR SBL SBR *2 *2 SBL SBR T-D (TheaterDimensional) ✔ ✔ ✔ ✔ DTS Surround Sensation ✔ ✔ ✔ ✔ Notes: *1 For 7ch output, output can be switched between Front high or Front wide speakers by pressing the [SP LAYOUT] button (depending on the "Speaker Configuration" setting (see page 95)). *2 For 9ch output, output can be switched between the combination of Surround back and Front high, or Surround back and Front wide speakers by pressing the [SP LAYOUT] button. *3 AV receiver can input the DSD signal from HDMI IN. Setting the output setting on the player side to PCM might obtain a better sound according to the player. In that case, set the output setting on the player side to PCM. *4 • This listening mode can be selected only when all the following conditions are satisfied: a. Center speaker is connected to the AV receiver. b. Either of Front High speakers or Front Wide speakers is connected to the AV receiver. • Output can be switched between Front high or Front wide speakers by pressing the [SP LAYOUT] button (depending on the "Speaker Configuration" setting (see page 95)). *5 This listening mode is not available while you are using Zone 2 ("Not Available" will appear on the display). If you turn Zone 2 on during the Pure Audio listening mode, the listening mode will change to Direct. *6 Depending on the input source, DTS is used. • Available sampling rate for PCM input signal is 32/44.1/48/88.2/96/176.4/192kHz. • The listening modes cannot be selected with some source formats. 87