Onkyo TX-NR3007 Owner Manual - Page 53
Notes, Through, 480p 480p/576p, 1080i, Source, Use the Up and Down, tons to select Resolution,
View all Onkyo TX-NR3007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
First Time Setup-Continued 5 Use the Up and Down [R]/[X] but- 6 Press the [SETUP] button. tons to select "Resolution", and The setup menu closes. use the Left and Right [F]/[S] buttons to select: Through: Select this to pass video through the AV receiver at the same resolution and with no conversion. Auto* : Select this to have the AV receiver automatically convert video at resolutions not supported by your TV. 480p (480p/576p): Select this for 480p or 576p output and video conversion as necessary. Notes: • See page 32 for charts showing how the "Monitor Out" and "Resolution" settings affect the video signal flow through the AV receiver. • This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button. 720p: Select this for 720p output and video conversion as necessary. 1080i: Select this for 1080i output and video conversion as necessary. 1080p* : Select this for 1080p output and video conversion as necessary. 1080p/24* : Select this for 1080p output at 24 frames per second and video conversion as necessary. Source: Output will be according to the resolution level which was set in the "Picture Adjust" setting (see page 105). Tips: • The "Resolution" setting can also be set using the [VIDEO] button on the remote controller. • The "Resolution" setting is set respectively of main, sub, and analog. Notes: • Settings marked with an asterisk (* ) are not available when the "Monitor Out" setting is set to "Analog". • If the "Monitor Out" setting is set to "Both", this setting is fixed at "Auto". • Depending on the incoming video signal, video playback may not be smooth or the vertical resolution may be lowered. In this case select other than "1080p/24". 53