Onkyo TX-NR3007 Owner Manual - Page 24
Bridging the Front Speakers A, Bridged Speaker Hookup
View all Onkyo TX-NR3007 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Connecting the AV receiver-Continued Bridging the Front Speakers A The FRONT L/R and SURR BACK/ZONE 3 L/R terminal posts can be used with front speakers and surround back speakers respectively, or bridged together to provide almost double the output power for the front speakers A. • When bridging is used, surround back speakers cannot be used. • For bridging, the positive (+) FRONT L/R and SURR BACK/ZONE 3 L/R terminal posts are used, but the negative (-) FRONT L/R and SURR BACK/ZONE 3 L/R terminals are not. • Once you've completed the bridging connections shown below and turned on the AV receiver, you must set the "Speakers Type(FrontA)" setting to "BTL" to enable bridging (see page 57). • When front Speakers A are bridged, front Speakers B must be wired normally or not used. Notes: • Use only front speakers with an impedance of 8 ohms or higher for bridging. Failure to do so may seriously damage the AV receiver. • When using bridging, make sure that your front speakers can handle the additional power. Bridged Speaker Hookup 1 Connect the AV receiver's FRONT R positive (+) terminal to the right speaker's positive (+) terminal. And connect the AV receiver's SURR BACK/ZONE 3 R positive (+) terminal to the right speaker's negative (-) terminal. 2 Connect the AV receiver's FRONT L positive (+) terminal to the left speaker's positive (+) terminal. And connect the AV receiver's SURR BACK/ZONE 3 L positive (+) terminal to the left speaker's negative (-) terminal. Right speaker Left speaker 24