Onkyo TX-NR3010 Owner Manual - Page 105

Zone 2/3 ■ There's no sound Only components connected to analog or HDMI (2ch - PCM) inputs can be played in Zone 2. Only components connected to analog inputs can be - played in Zone 3. ■ The Zone 2/3 speakers produce no sound See "Multi Zone" for the conditions in which 87 Powered Zone 2/3 cannot be used. To use the Zone 2 speakers, you must set the 66 "Powered Zone 2" setting to "Yes". To use the Zone 3 speakers, you must set the 66 "Powered Zone 3" setting to "Yes". Music Server and Internet Radio ■ Can't access the server or Internet radio Check the network connection between the AV 118 receiver and your router or switch. Make sure that your modem and router are properly - connected, and make sure they are both turned on. Make sure the server is up and running and 119 compatible with the AV receiver. Check the "Network"settings. 85 ■ Playback stops while listening to music files on the server Make sure your server is compatible with the AV 119 receiver. If you download or copy large files on your - computer, playback may be interrupted. Try closing any unused programs, use a more powerful computer, or use a dedicated server. If the server is serving large music files to several - networked devices simultaneously, the network may become overloaded and playback may be interrupted. Reduce the number of playback devices on the network, upgrade your network, or use a switch instead of a hub. ■ Can't connect to the AV receiver from a Web browser If you're using DHCP, your router may not always 85 allocate the same IP address to the AV receiver, so if you find that you can't connect to a server or Internet radio station, recheck the AV receiver's IP address on the "Network" screen. Check the "Network" settings. 85 USB Device Playback ■ Can't access the music files on a USB device Make sure the USB device is plugged in properly. - The AV receiver supports USB devices that support 119 the USB mass storage device class. However, playback may not be possible with some USB devices even if they conform to the USB mass storage device class. USB memory devices with security functions cannot - be played. Others ■ Standby power consumption In the following cases, the power consumption in 83, 84, standby mode may reach up to a maximum of 86 12.5 W: - The "HDMI Control(RIHD)" setting is set to "On". (Depending on the TV status, the AV receiver will enter standby mode as usual.) - The "HDMI Through" setting is set to other than "Off". - The "Network Standby" setting is set to "On". Appendix If an MHL-enabled mobile device is connected to the 21 AUX (front) input, the power consumption in standby mode will increase. ■ The sound changes when I connect my headphones When a pair of headphones is connected, the listening - mode is set to Stereo, unless it's already set to Stereo, Mono, Direct, or Pure Audio. ■ The speaker distance cannot be set as required The values entered may be automatically adjusted - with values best-suited for your home theater. ■ The display doesn't work The display is turned off when the Pure Audio - listening mode is selected. ■ How do I change the language of a multiplex source Use the "Multiplex" setting in the "Audio Adjust" 72 menu to select "Main" or "Sub". ■ The V functions don't work To use V, you must make an V connection and an 25 analog audio connection (RCA) between the component and AV receiver, even if they are connected digitally. While Zone 2/3 is selected, the V functions don't 25 work. ■ The functions System Off/Auto Power On and Direct Change don't work for components connected via V These functions don't work when Zone 2/3 is turned 25 on. En-105