Onkyo TX-NR3010 Owner Manual - Page 56

Using Headphones 1 Connect a pair of stereo headphones with a standard plug (1/4 inch or 6.3 mm) to the PHONES jack. While the headphones plug is inserted in the PHONES jack,  indicator, speaker/channel indicator FL and FR lights. Note • Always turn down the volume before connecting your headphones. • While the headphones plug is inserted in the PHONES jack, the speakers are turned off. (The Powered Zone 2/3 speakers are not turned off.) • When you connect a pair of headphones, the listening mode is set to Stereo, unless it's already set to Stereo, Mono, Direct, or Pure Audio. • If you connect an iPod or iPhone to the USB port on the AV receiver, no sound will be output from the headphones jack. Using Easy Macros By using ACTIVITIES in Easy macro mode, you can sequentially operate Onkyo components via simple commands from a single-button press. These commands are user-definable. See "Using Normal Macros" (➔ page 100). 1 Press ACTIVITIES (MY MOVIE, MY TV, or MY MUSIC) to start the Easy macro command. The default sequences of actions are described below. To change the related source component, see "Changing the Source Components" shown later in this chapter. ■ MY MOVIE First, the TV, the Onkyo Blu-ray Disc player, and the AV receiver are turned on. The input selector is set to "BD/DVD". Finally the player starts playback.*1 *1 Depending on the start-up time of your Blu-ray Disc/DVD player, the AV receiver may not activate this playback command. In this case, press  on the remote controller. ■ MY TV First, the TV, the cable set-top box, and the AV receiver are turned on. Then the input selector is set to "CBL/SAT". ■ MY MUSIC The Onkyo CD player and the AV receiver are turned on. The input selector is set to "TV/CD". Finally, the player starts playback. Note • While the Easy Macro command is being processed, you cannot use other ACTIVITIES. If you want to operate other components, first press ALL OFF and use the desired ACTIVITIES. Turning Off the Components This button turns off all components activated by the Easy Macro mode. 1 Press ALL OFF. First, the related components stop and turn off. Second, the AV receiver turns off. Finally, the TV turns off (or enters standby mode).*1*2 *1 This step doesn't apply to MY MUSIC, with the default settings. *2 With some televisions, the power may not be turned off (or enter standby mode). Turning On & Basic Operations Changing the Source Components You can change the source components activated by the Easy Macro mode. 1 While holding down REMOTE MODE for the playback component you wish to assign, press and hold down the ACTIVITIES to be changed (MY MOVIE, MY TV, or MY MUSIC) (about 3 seconds). ACTIVITIES flashes twice, indicating that the change is complete. Examples: If you wished to use MY MUSIC to start the Onkyo cassette recorder, you would press and hold down MY MUSIC (about 3 seconds) while holding down TV/CD until it flashes twice. Restoring Default You can restore ACTIVITIES to the default settings. 1 While holding down HOME, press and hold down ALL OFF until ALL OFF lights (about 3 seconds). 2 Release HOME and ALL OFF, and press ALL OFF again. ALL OFF flashes twice. En-56