Onkyo TX-NR3010 Owner Manual - Page 81

Setting the Incoming Digital Signal (Fixed Mode) ■ Fixed Mode ` Off: The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead. ` PCM: Only 2-channel PCM format input signals will be heard. If the input signal is not PCM, the PCM indicator will flash and noise may also be produced. ` DTS: Only DTS (but not DTS-HD) format input signals will be heard. If the input signal is not DTS, the dts indicator will flash and there will be no sound. When "HDMI", "COAXIAL" or "OPTICAL" is selected in the "Audio Selector" setting, you can then specify the signal type in "Fixed Mode". Normally, the AV receiver detects the signal format automatically. However, if you experience either of the following issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS. • If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM. • If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS. Note • The setting will be reset to "Off" when you change the setting in "Audio Selector". Listening Mode Preset 1 2 3 4 5 "Setup" Main Menu Listening Mode Preset You can assign a default listening mode to each input source that will be selected automatically when you select each input source. For example, you can set the default listening mode to be used with Dolby Digital input signals. You can select other listening modes during playback, but the mode specified here will be resumed once the AV receiver has been set to standby. 1 Use R/X to select the input source that you want to set, and then press ENTER. The following menu appears. 5-1. Listening Mode Preset Analog/PCM Mono/Multiplex Source 2ch Source Dolby D/Dolby D Plus/TrueHD DTS/DTS-ES/DTS-HD Other Multich Source BD/DVD Last Valid F S Last Valid Last Valid Last Valid Last Valid Last Valid Default listening mode for analog and PCM sources. Advanced Operations 2 Use R/X to select the signal format that you want to set, and then use F/S to select a listening mode. Only listening modes that can be used with each input signal format can be selected (➔ pages 45 to 52). The "Last Valid" option means that the listening mode selected last will be used. The "Straight Decode" option means that straight decoding listening mode (Dolby Digital, DTS, etc.) is selected. Note • For the "TUNER" input selector, only "Analog" will be available. • For the "NET" or "USB" input selector, only "Digital" will be available. ■ Analog/PCM/Digital With this setting, you can specify the listening mode used when an analog (CD, TV, LD, VHS, MD, turntable, radio, cassette, cable, satellite, etc.) or PCM digital (CD, DVD, etc.) audio signal is played. Note • For the "GAME2" input selector, only "PCM" is available. ■ Mono/Multiplex Source With this setting, you can specify the listening mode used when a mono digital audio signal is played (DVD, etc.). ■ 2ch Source With this setting, you can specify the listening mode used when 2-channel (2/0) stereo digital sources, such as Dolby Digital or DTS, are played. En-81