Onkyo TX-NR3010 Owner Manual - Page 44
En-44, Error Messages - review
View all Onkyo TX-NR3010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
9 Use R/X to select an option, and then press ENTER. MultEQ XT32: Auto Setup Subwoofer Front Center Surround Front Wide Front High Surround Back Surround Back Ch -- Review Speaker Configuration -- 2ch 40Hz 40Hz 100Hz None 100Hz 120Hz 2ch AUDYSSEY Save Cancel The options are: ` Save: Save the calculated settings and exit Audyssey MultEQ® XT32 Room Correction and Speaker Setup. ` Cancel: Cancel Audyssey MultEQ XT32 Room Correction and Speaker Setup. Tip • You can view the calculated settings for the speaker configuration, speaker distances, and speaker levels by using F/S. 10 Use R/X to select a target, and use F/S to change the setting. After the results of Audyssey MultEQ XT32 have been saved, the menu will display the "Audyssey" (➔ page 76), "Dynamic EQ" (➔ page 76), "Dynamic Volume" (➔ page 76) settings. Note • When "Audyssey Quick Start" has been used for measurement, "Audyssey" cannot be selected. • These settings are applied to all input selectors. 11 Press ENTER. 12 Disconnect the speaker setup microphone. Note • You can cancel Audyssey MultEQ XT32 Room Correction and Speaker Setup at any point in this procedure simply by disconnecting the setup microphone. • Do not connect or disconnect any speakers during Audyssey MultEQ XT32 Room Correction and Speaker Setup. • If the AV receiver is muted, it will be unmuted automatically when Audyssey MultEQ XT32 Room Correction and Speaker Setup starts. • Changes to the room after Audyssey MultEQ XT32 Room Correction and Speaker Setup requires you run Audyssey MultEQ XT32 Room Correction and Speaker Setup again, as room EQ characteristics may have changed. Turning On & Basic Operations Error Messages While Audyssey MultEQ XT32 Room Correction and Speaker Setup is in progress, one of the error messages below may appear. MultEQ XT32: Auto Setup Ambient noise is too high. AUDYSSEY Retry Cancel Error message The options are: ` Retry: Try again. ` Cancel: Cancel Audyssey MultEQ XT32 Room Correction and Speaker Setup. • Ambient noise is too high. The background noise is too loud. Remove the source of the noise and try again. • Speaker Matching Error! The number of speakers detected was different from that of the first measurement. Check the speaker connection. • Writing Error! This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, contact your Onkyo dealer. • Speaker Detect Error This message appears if a speaker is not detected. "No" means that no speaker was detected. Tip • See "Speaker Configuration" for appropriate settings (➔ page 13). En-44