Onkyo TX-NR3010 Owner Manual - Page 88
Connecting the Zone Speakers to an, Additional Amplifier, 12V Trigger Out, Zone 2 Video Output, En-88
View all Onkyo TX-NR3010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Connecting the Zone Speakers to an Additional Amplifier This setup allows 9.2-channel playback in your main listening room and 2-channel stereo playback in Zone 2/3. Main room TV 12V Trigger Out When Zone 2/3 is turned on, the output from the 12V TRIGGER OUT jack goes high (+12 V and max. 150 mA for Zone 2, +12 V and max. 25 mA for Zone 3). Connecting this jack to a 12-volt trigger input on a component in Zone 2/3 will make that component turn on or off as the AV receiver turns on or off the Zone 2/3. Zone 2 Video Output Advanced Operations Note • If you use HDMI OUT ZONE 2, make sure to set "Zone 2 HDMI" to "Use" (➔ page 63). • Video and audio signals from an HDMI input will be output to HDMI OUT ZONE 2. • The ZONE 2 OUT V jack outputs video of components connected to composite video only. • The information of connected component appears on a TV in Zone 2 by pressing DISPLAY. AV receiver Zone 2 The on-screen information appears on the TV screen in Zone 2 by connecting the TV to HDMI OUT ZONE 2 of the AV receiver with HDMI cable. The AV receiver allows you to enjoy the composite video and HDMI audio/video in Zone 2 by connecting the TV of Zone 2 to the respective output jacks. Main room TV Receiver/ integrated amp Zone 3 Receiver/ integrated amp Note • The volume of Zone 2/3 must be set on the Zone 2/3 amplifier. Zone 2 AV receiver or TV En-88