Onkyo TX-NR3010 Owner Manual - Page 91
Using a Multiroom Kit with a Cabinet, Components, En-91
View all Onkyo TX-NR3010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
From the connecting block Miniplug cable AV receiver Signal flow Using a Multiroom Kit with a Cabinet In this setup, the IR receiver picks up the infrared signals from the remote controller and feeds them to the AV receiver located in the cabinet via the connecting block. IR IN Connecting block IR receiver Inside cabinet Signal flow Remote controller Using a Multiroom Kit with Other Components In this setup, an IR emitter is connected to the AV receiver's IR OUT jack and placed in front of the other component's remote control sensor. Infrared signals received at the AV receiver's IR IN jack are fed through to the other component via the IR emitter. Signals picked up by the AV receiver's remote control sensor are not output. IR IN IR OUT Connecting block AV receiver IR Emitter IR receiver Remote controller Other component Signal flow The IR emitter should be connected to the AV receiver's IR OUT jack, as shown below. From the connecting block Miniplug cable Other component Remote control sensor AV receiver Emitter IR Emitter Miniplug Signal flow En-91 Advanced Operations